Tag Archives: Erich Neitzke

If only every mistake could be fixed with Bondo

The English language needs a word for that chilly feeling of regret that washes over you, followed by the hot flush that confirms that you just made a terrible mistake. In relief printmaking, this comes when you have carved away a portion of your block that you had not intended. This happened to me recently, and after I discarded the possibility of having a toddler-style tantrum on the floor, I turned to Google.

Thankfully, me eyes soon rested on a blog post by Erich Neitzke on how to use Bondo to repair a linoleum block. My only experience with Bondo comes from my childhood, when I would help my father use Bondo and fiberglass mesh to patch our 1967 Volvo. After reading Erich’s blog, I headed to the hardware store to give Bondo a try on my block.

Can of Bondo

Yep, they still make Bondo. You shouldn’t need the fiberglass kit.

My trouble came from my carelessness when using a mask or frisket to block out part of the linoleum. A mask is simply a packing tape covered piece of tracing paper that physically covers part of the block so the roller can’t deposit the ink. The result is an ink/no ink line. The actual mask that I created was slightly different from the lines on my tracing paper drawing, but I had forgotten this, and merrily began carving away the incorrect lines. This would mean that there would be a strange white space between my yellow sky and purple mountains. There was no way to glue back the pieces of linoleum with Superglue, which only works on minute areas where the linoleum is somewhat attached.

Masking tape around the mistakenly carved linoleum.

Masking around the area means that you will have less area to sand later.

Armed with my Bondo, I first masked around the area I wanted to fill with blue tape. I mixed a small amount of the white compound from the can, with a tiny amount of the brick red paste from the accompanying tube. I used a Dixie cup as a container and a popsicle stick for mixing and spreading. Make sure to use gloves and have proper ventilation. (Don’t do this inside.)

Bondo is spread over the area.

Press the Bondo firmly over the area, and don’t scrape down too deep. You want it to be a little bit higher than the block at this point.

I quickly spread the Bondo firmly into the channel I wanted to fill and scraped down some of the excess. You will want to leave a raised mound that you can sand. Bondo cures, rather than dries, so I was able to start sanding after an hour.

The linoleum has been patched by Bondo, but must be sanded.

Remove the masking tape. Now it is time to gently sand by hand.

After removing the masking tape, I began sanding with 220 paper. I was careful not to sand too far down, as then I might get small lines around the filled area that might print. This patch will work if you have relatively small areas to fill, or if you fill in several steps. It might be hard to fill an area that is not surrounded on most sides by linoleum.

Pencil marks now show the correct place to carve.

The correctly carving marks are transferred to the block, with a written reminder.

After the sanding, I carefully transferred the correct marks to the block, and reminded myself where to carve. It is always better for colors to overlap slightly than to have those unsightly white lines. You can always carve away more later.

After two colors, the Bondo area is still holding well. My diptych of cumulonimbus clouds was saved. If only other problems were so easy to solve with a simple patch and some sanding.

Share